D.T.Systems Super Trainer EZT plus 5002 Manuel du propriétaire télécharger pdf (Page 11)

Transmitter Indicator Light

When one of the push button switches on the

transmitter are pushed, the RED light will turn on to

indicate that the transmitter is being operated. When

the battery needs charging the RED light will blink

once every

112 second while pushing a button.

Transmitter Antenna

Be very careful when screwing the

antenna into the

transmitter. Hand tighten only. Over tightening could

cause damage to the antenna or the antenna mount.

Remote Training

~uttons

Pressing the upper button causes the collar to

administer a Momentary Stimulation or 'Nick'.

Pressing the lower button gives the Continuous

Stimulation.

Locate and RunlPoint Buttons

Pressing the 'Locate' button on the left side of the

Transmitter will make the Collar Receiver beep.

Pressing the 'RunlPoint' button on the right side of the

Transmitter will activate the RunlPoint mode on the

Collar Receiver. Press it again and it will go into the

Point only mode. Press the 'Locate' button to cancel

the RunlPoint modes.

Two Don Model Selection Switch

(EZT plus

5002)

Switching between units can be controlled by moving

the toggle selection switch to the desired unit.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Pas de commentaire

D.T.Systems Super Trainer EZT plus 5002 Manuel du propriétaire Page 11