D.T.Systems R.A.P.T. 1400 Manuel du propriétaire télécharger pdf (Page 10)

PARTS & FUNCTIONS

CAUTION

If the collar belt is too long, we recommend looping the ex-

cess collar belt back around through the buckle. We DO

NOT recommend cutting the collar belt. Cutting the collar

belt too short can drastically reduce the range of your collar

unit. However, the collar belt can be cut up to about 3

inches without affecting the range too much.

Collar Belt with MAXX-Range™ 360 Antenna - The

embedded MAXX-Range™ Antenna is woven into the

collar belt and runs along the entire length of the belt,

providing extended range without the drawback of an

external antenna. Because it wraps around the neck

along with the collar belt, the MAXX-Range Antenna

provides 360˚ degrees of signal reception and is not

blocked by your dog’s body, regardless of which

direction your dog is facing.

NOTE

The unit is still waterproof even if water gets into the charg-

ing receptacle. However, if water should get in, we recom-

mend rinsing out the charging receptacle and allowing it to

dry, especially after use in salt water. This will prevent pre-

mature corrosion in the metal pins inside that make contact

with the charger plug.

Battery Charging Receptacles - The charger cables

plug into the Charging Receptacle for recharging

(located on the side of the Collar Receiver facing the

dog’s neck). After charging, always close the Charg-

ing Receptacle with the rubber plug to prevent

foreign particles from getting inside the unit.

Re-Thread SureGrip Strap

1. With the buckle of the strap fac-

ing outwards, thread the suregrip

strap through the bottom guide.

2. Thread both sides of the sure-

grip strap through the neoprene

3. Thread loose end (non-buckle

end) of the strap through the top

4. Thread loose end through the

top-portion of buckle as shown.

1 2 ... 5 6 7 8 9 10 11 12

Pas de commentaire

D.T.Systems R.A.P.T. 1400 Manuel du propriétaire Page 10